Enterasys Matrix DFE-Gold Series

Configuring System Logging set logging application
10-10 System Logging Configuration
Defaults
•Iflevelisnotspecified,nonewillbeapplied.
•Ifserverisnotspecified,messageswillbesenttoallSyslogservers.
Mode
Switchcommand,Read‐Write.
Usage
MnemonicvaluesarecasesensitiveandmustbetypedastheyappearinTable 10‐3.
Example
ThisexampleshowshowtosettheseveritylevelforSSH(SecureShell)to4sothaterror
conditionswillbeloggedforthatapplicationandsenttoSyslogserver1:
Matrix(rw)->set logging application SSH level 4 server 1
Table 10-3 Sample Mnemonic Values for Logging Applications
Mnemonic Application
AAA Authentication, Authorization, & Accounting
AddrNtfy Address Add and Move Notification
CLI Command Line Interface
FlowLimit Flow Limiting
LACP Link Aggregation Control Protocol
OSPF Open Shortest Path First Routing Protocol
Router Router
RtrAcl Router Access Control List
RtrFE Router Forwarding Engine
RtrArpProc Router Arp Process
RtrLSNat Router Load Sharing Network Address Translation
SNMP Simple Network Management Protocol
System Non-Application items such as general blade/chassis/
configurations, etc.
Trace Router Tracing
UPN User Personalized Networking
VRRP Virtual Router Redundancy Protocol
Webview Webview Device Management