Enterasys Matrix DFE-Gold Series

set multiauth session-timeout Configuring Multiple Authentication
Enterasys Matrix DFE-Gold Series Configuration Guide 27-13
set multiauth session-timeout
Usethiscommandtosetthemaximumnumberofsecondsanauthenticatedsessionmaylast
beforeterminationofthesession.
Syntax
set multiauth session-timeout [cep | dot1x | mac | pwa] timeout
Parameters
Defaults
Ifnoauthenticationtypeisspecified,thetimeoutvalueissetforalltypes.
Mode
Switchcommand,Read‐Write.
Usage
Avalueofzeromaybesupersededbyasessiontimeoutvalueprovidedbythe au thenticating
server.Forexample,ifasessionisauthenticatedbyaRADIUSserver,thatservermayencodea
Session‐TimeoutAttributeinitsauthentication response.
Examples
Thisexampleshowshowtosetthesession‐timeoutvalueforanactivesession,forcepandmac
authenticationto500seconds:
Matrix(rw)->set multiauth session-timeout cep 500
Matrix(rw)->set multiauth session-timeout mac 500
Thisexampleshowshowtosetthesession‐timeoutvalueforanactivesession,forallthe
authenticationtypesto600seconds:
Matrix(rw)->set multiauth session-timeout 600
cep (Optional)SpecifiestheauthenticationtypeEnterasysConvergence
EndPointAuthentication.
dot1x (Optional)SpecifiestheauthenticationtypeIEEE802.1XPort‐Based
NetworkAccessControl.
mac (Optional)SpecifiestheauthenticationtypeEnterasysMac
Authentication.
pwa (Optional)SpecifiestheauthenticationtypeEnterasysPortWeb
Authentication.
timeout Specifiesthetimeoutvalueinseconds.Thevaluecanrangefrom
0to
65535.Avalueof0meansthatnosessiontimeoutwillbeappliedunless
asessiontimeoutvalueisprovidedbytheauthenticatingserver.