Configuring Convergence End Points (CEP) Phone Detection show cep port
25-42 Authentication Configuration
Examples
ThisexampleshowshowtodisplayCEPpolicyinformation:
Matrix>show cep policy
CEP default policies
CEP Type Policy Index Policy Name
-------- ------------ ------------
cisco 13 Cisco IP Phone
siemens 9 IP Phone Siemens
h323 3 IP Phone Avaya
sip 0
show cep port
UsethiscommandtodisplayenablestatusofallsupportedCEPtypes.
Syntax
show cep port port-string
Parameters
Defaults
None
Mode
Read‐Only.
Examples
ThisexampleshowshowtodisplayCEPstatusinformationforportfe.1.21:
Matrix>show cep port fe.1.21
Port H323 Siemens Cisco SIP
---------- -------- -------- -------- --------
fe.1.21 enabled enabled enabled disabled
set cep
UsethiscommandtogloballyenableordisableCEPdetection.
Syntax
set cep {enable | disable}
Parameters
port‐string DisplaysCEPstatusforoneormoreports.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage 4‐2.
enable|disable GloballyenablesordisablesCEPdetection.