Enterasys Matrix DFE-Gold Series

set rmon topN properties Configuring RMON
Enterasys Matrix DFE-Gold Series Configuration Guide 11-31
set rmon topN properties
UsethiscommandtoconfigureanRMONtopNentry(report).
Syntax
set rmon topn properties index [hindex hindex] [rate {inpackets | outpackets |
inoctets | outoctets | errors | bcast | mcast}] [duration duration] [size size]
[owner owner]
Parameters
Defaults
•Ifhostindexisnotspecified,nonewillbeapplied.
•Ifcountertypeisnotspecified,inpacketswillbeapplied.
•Ifdurationisnotspecified,nonewillbeapplied.
•Ifsizeisnotspecified,10willbeapplied.
•Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoconfigureRMONTopNentry1,forhost1withasamplingintervalof
60secondsandamaximumnumberofentriesof20:
Matrix(rw)->set rmon topN properties 1 1 inpackets 60 20
set rmon topN status
UsethiscommandtoenableanRMONtopNentry.
Syntax
set rmon topN status index enable |
index Specifiesanindexnumberforthisentry.Anentrywillautomaticallybe
createdifanunusedindexnumberischosen.Maximumnumberof
entriesis10.Maximum valueis65535.
hindexhindex (Optional)Specifiesanindexnumberofthehosttable.
rateinpackets|
outpackets|inoctets
|outoctets|
errors|
bcast|mcast
(Optional)Specifiesthetypeofcountertoactivatewiththisentryas
InPackets,OutPackets,InOctets,OutOctets,OutErrors,Broadcast
packets,orMulticastpackets.
durationduration (Optional)Specifiesthesamplingintervalinseconds.Valuemustbea
minimumof60.
sizesize (Optional)Specifiesthemaximumnumberofentriesto
maintain.
ownerowner (Optional)Specifiesthenameoftheentitythatconfiguredthisentry.