Configuring VRRP show ip vrrp
21-72 Routing Protocol Configuration
Table 21-7 show ip vrrp Output Details
Output... What it displays...
Vlan Specifies the VLAN on which this VRRP session resides.
Vrid Specifies the Virtual Router ID associated with the routing interface.
State Specifies the current state of the VRRP session as follows:
Stopped - The Vrid is disabled.
Init - The session is waiting in the init state. The vrid must be down due
to the priority being set to zero, because one or more of the assigned
critical ip interfaces has decremented the priority to 0.
Backup - The Vrid is operating in the backup state.
Master - The Vrid is operating in the master state.
ifDown - The Vrid is down because the interface is not operational.
PreemptDel - The Vrid is in a preempt delay state while transitioning to
master.
Owner Specifies whether this router owns the associated IP address as one of
its interfaces. Valid values are:
• 1 to indicate the router owns the address.
• 0 to indicate the router does not own the address.
AssocIpAddr Specifies the virtual IP address(es) associated with this VRRP session.
Priority Specifies the priority value for this Vrid.
VirtMacAddr Specifies the virtual MAC address for this VRRP session.
To Next Page
Loading...
Need help?
General