Enterasys Matrix DFE-Gold Series

clear multiauth idle-timeout Configuring Multiple Authentication
Enterasys Matrix DFE-Gold Series Configuration Guide 27-11
Defaults
Ifnoauthenticationmethodisspecified,thetimeoutvalueissetforallmethods.
Mode
Switchcommand,Read‐Write.
Usage
Avalueofzeroindicatesthatnoidletimeoutwillbeappliedunlessanidletimeoutvalueis
providedbytheauthenticatingserver.Forexample,ifasessionisauthenticatedbyaRADIUS
server,thatservermayencodeaIdle‐TimeoutAttributeinitsauthenticationresponse.
Examples
Thisexampleshowshowtosettheidle‐timeoutsessionforcepandmacauthenticationto500
seconds:
Matrix(rw)->set multiauth idle-timeout cep 500
Matrix(rw)->set multiauth idle-timeout mac 500
Thisexampleshowshowtosettheidle‐timeoutsessionforalltheauthenticationtypesto600
seconds:
Matrix(rw)->set multiauth idle-timeout 600
clear multiauth idle-timeout
Usethiscommandtoresetthemaximumnumberofconsecutivesecondsanauthenticatedsession
maybeidlebeforeterminationofthesessiontothedefaultvalueof300seconds.
Syntax
clear multiauth idle-timeout [cep | dot1x | mac | pwa]
Parameters
mac (Optional)SpecifiestheauthenticationtypeEnterasysMac
Authentication.
pwa (Optional)SpecifiestheauthenticationtypeEnterasysPortWeb
Authentication.
timeout Specifiesthetimeoutvalueinseconds.Thevaluecanrangefrom0to
65535.Avalueof0meansthatnoidletimeoutwillbeappliedunlessan
idletimeoutvalueisprovided
bytheauthenticatingserver.Thedefault
timeoutvalueis300seconds.
cep (Optional)SpecifiestheauthenticationtypeEnterasysConvergence
EndPointAuthentication.
dot1x (Optional)SpecifiestheauthenticationtypeIEEE802.1XPort‐Based
NetworkAccessControl.
mac (Optional)SpecifiestheauthenticationtypeEnterasysMac
Authentication.
pwa (Optional)SpecifiestheauthenticationtypeEnterasysPortWeb
Authentication.