To Next Page

To Previous Page

Configuring LACP set lacp static

4-62 Port Configuration

Defaults

None.

Mode

Switchcommand,Read‐Write.

Example

Thisexampleshowshowtocleartheactor adminkeyforLAGport4:

Matrix(rw)->clear lacp aadminkey lag.0.484

set lacp static

UsethiscommandtoassignoneormoreunderlyingphysicalportstoaLinkAggregationGroup

(LAG).MatrixDFE‐GoldSeriesdevicesallowforuptofourportsperaggregator.

Syntax

setlacpstaticlagportstring[key]port‐string

Parameters

Defaults

Ifnotspecified,akeywillbeassignedaccordingtothespecifiedaggregator.Forexampleakeyof4

wouldbeassignedtolag.0.4.

Mode

Switchcommand,Read‐Write.

Usage

AtleasttwoportsneedtobeassignedtoaLAGportforaLinkAggregationGrouptoformand

attachtothespecifiedLAGport.

ThesameusageconsiderationsfordynamicLAGsdiscussedin“MatrixSeriesUsage

Considerations”onpage 4‐56applytostaticallycreatedLAGs.

StaticLAGconfigurationshould

beperformedbypersonnelwhoareknowledgeableaboutLink

Aggregation.MisconfigurationcanresultinLAGsnotbeingformed,orinportsattachingtothe

wrongLAGport,affectingpropernetworkoperation.

lagportstring SpecifiestheLAGaggregatorporttowhichnewportswillbeassigned.

key (Optional)Specifiesthenewmemberportand

LAGportaggregator

adminkeyvalue.Onlyportswithmatchingkeysareallowedto

aggregate.Validvaluesare0‐65535.

Note: This key value must be unique. If ports other than the desired underlying

physical ports share the same admin key value, aggregation will fail or

undesired aggregations will form.

port‐string Specifiesthememberport(s)toaddtotheLAG.Foradetailed

descriptionofpossibleport‐stringvalues,referto“PortStringSyntax

UsedintheCLI”onpage 4 ‐2.

Enterasys Matrix DFE-Gold Series User Manual

Questions and Answers: