Enterasys Matrix DFE-Gold Series

show ip route Managing Switch Network Addresses and Routes
Enterasys Matrix DFE-Gold Series Configuration Guide 12-5
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
TheEnterasysMatrixSeriesdeviceusesBOOTP/DHCPtoobtainanIPaddressifonehasn’tbeen
configured.RADcanalsobeusedtoretrieveatextconfigurationfilefromthenetwork.
InorderforRADtoretrieveatextconfigurationfile,thefilemustbespecifiedintheBootPtab.
RADon
DFEdeviceswillonlyacceptanaddressfromaDHCPorBootPserveriftheleasetimefor
theaddressissettoinfinity(unlimited).ThiswillpreventtheDFEfromswitchingaddresseswhen
aleasetimeexpires.
Example
ThisexampleshowshowtodisableRAD:
Matrix(rw)->set rad disable
show ip route
Usethiscommandtodisplaytheswitch’sIProutingtableentries.
Syntax
show ip route
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheIProutingtable:
Matrix(rw)->show ip route
ROUTE TABLE
Destination Gateway Mask TOS Flags Refcnt Use Interface
------------------------------------------------------------------------------
default 12.22.73.13 00000000 0 UC 0 0 host0
10.0.0.0 12.22.73.13 ff000000 0 UC 0 host0
127.0.0.1 127.0.0.1 00000000 0 UH 0 104 lo0
Table 12‐2providesanexplanationofthecommandoutput.