Enterasys Matrix DFE-Gold Series

show cdp Enterasys Discovery Protocol
Enterasys Matrix DFE-Gold Series Configuration Guide 3-3
Enterasys Discovery Protocol
Purpose
Toenableandconfigurethe EnterasysDiscoveryProtocol(CDP),usedtodiscovernetwork
topology.Whenenabled,CDPallowsEnterasysdevicestosendperiodicPDUsaboutthemselves
toneighboringdevices.
Commands
show cdp
UsethiscommandtodisplaythestatusoftheCDPdiscoveryprotocolandmessageintervalon
oneormoreports.
Syntax
show cdp [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,allCDPinformationwillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplayCDPinformationforportsfe.1.1throughfe.1.9:
Matrix(rw)->show cdp fe.1.1-9
CDP Global Status : enabled
CDP Versions Supported : 0x0 0x38
CDP Hold Time : 180
For information about... Refer to page...
show cdp 3-3
set cdp state 3-4
set cdp auth 3-5
set cdp interval 3-6
set cdp hold-time 3-6
clear cdp 3-7
port‐string (Optional)DisplaysCDPstatusforaspecificport.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.