Enterasys Matrix DFE-Gold Series

Configuring Simple Network Time Protocol (SNTP) set sntp poll-timeout
13-8 SNTP Configuration
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoclearthenumberofSNTPpollretries:
Matrix(rw)->clear sntp poll-retry
set sntp poll-timeout
Usethiscommandtosetthepolltimeout(inseconds)foraresponsetoaunicastSNTPrequest.
Syntax
set sntp poll-timeout timeout
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosettheSNTPpolltimeoutto10seconds:
Matrix(rw)->set sntp poll-timeout 10
clear sntp poll-timeout
UsethiscommandtocleartheSNTPpolltimeout.
Syntax
clear sntp poll-timeout
Parameters
None.
Defaults
None.
timeout Specifiesthepolltimeoutinseconds.Validvaluesare1to30.