Enterasys Matrix DFE-Gold Series - Client-Identifier

client-identifier DHCP Overview
Enterasys Matrix DFE-Gold Series Configuration Guide 20-17
Parameters
Defaults
None.
Mode
Routercommand,AnyDHCPconfigurationmode.
Usage
Usingthiscommandtogiveasetofclientclasspropertiesaname,allowsyoutoassignproperties
toallDHCPclientswithintheclassratherthanconfiguringeachclientseparately.Thiscommand
alsoenablesDHCPclassconfigurationmode.
The“no”formofthiscommanddeletesaclientclassname.
Example
Thisexampleshowshowtoassign“clientclass1”asaclientclassnameinthe“localpool”address
pool:
Matrix>Router(config)#ip dhcp pool localpool
Matrix>Router(config-dhcp-pool)#client-class clientclass1
client-identifier
UsethiscommandtoenableDHCPhostconfigurationmodeandassociateaclientclasswitha
DHCPclient.
Syntax
client-identifier mac-address [client-class name]
no client-identifier unique-identifier
Parameters
Defaults
Ifclient‐classisnotspecified,nonewillbeassigned.
Mode
Routercommand,AnyDHCPconfigurationmode.
Usage
The“no”formofthiscommanddeletesaclientidentifier.
name SpecifiesanameforaDHCPclientclass.
mac‐address Specifiestheclient’sMACaddress.
client‐classname (Optional)Specifiestheclasstowhichthisclientwillbeassigned.Must
beconfiguredusingtheclient‐classnameasdescribedin“client‐class”
onpage 20‐16.