Enterasys Matrix DFE-Gold Series

Configuring Port Web Authentication (PWA) set pwa maxrequests
25-24 Authentication Configuration
Defaults
Ifport‐stringisnotspecified,quietperiodwillbesetforallports.
Mode
Read‐Write.
Example
ThisexampleshowshowtosetthePWAquietperiodto30secondsforportsfe.1.5‐7:
Matrix(rw)->set pwa quietperiod 30 fe.1.5-7
set pwa maxrequests
Usethiscommandtosetthemaximumnumberoflogonattemptsallowedbeforetransitioning
thePWAporttoaheldstate.
Syntax
set pwa maxrequests maxrequests [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,maximumrequestswillbesetforallports.
Mode
Read‐Write.
Example
ThisexampleshowshowtosetthePWAmaximumrequeststo3forallports:
Matrix(rw)->set pwa maxrequests 3
set pwa portcontrol
UsethiscommandtosetthePWAportcontrolmode.
Syntax
set pwa portcontrol {enable | disable} [port-string]
maxrequests Specifiesthemaximumnumberoflogonattempts.
port‐string (Optional)Setsthemaximumrequestsforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.