Enterasys Matrix DFE-Gold Series

Configuring PIM ip pim rp-address
17-4 PIM Configuration
Mode
Routercommand,Interfaceconfiguration:Matrix>Router(config‐if(Vlan1))#
Usage
The“no”formofthiscommanddisablestheDRfunctionality.
Example
ThisexamplesetstheDRpriority to20onVLAN1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip pim dr-priority 20
ip pim rp-address
Usethiscommandtosetastaticrendezvouspoint(RP)foramult icastgroup.
Syntax
ip pim rp-address rp-address group-address group-mask [priority priority]
no ip rp-address rp-address group-address group-mask
Parameters
Defaults
Ifnotspecified,apriorityvalueof192willbeassigned.
Mode
Routercommand,Globalconfiguration:Matrix>Router(config)#
Usage
The“no”formofthiscommandremovesthestaticRPconfiguration.
Example
ThisexamplesetsastaticRPaddressat10.0.0.1forthemulticastgroupat235.0.0255.0.0:
Matrix>Router(config)#ip pim rp-address 10.0.0.1 235.0.0.0. 255.0.0.0
rp‐address SpecifiestheIPaddressofthePIMRProuter.
group‐address Specifiesthemulticastgroupaddress.
group‐mask Specifiesthemulticastgroupmask.
prioritypriority (Optional)SpecifiesanRPpriorityvalue,rangingfrom0‐255.Lower
valuesassignhigherpriority.