Managing Switch Network Addresses and Routes show arp
12-2 Network Address and Route Management Configuration
show arp
Usethiscommandtodisplaytheswitch’sARPtable.
Syntax
show arp
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheARPtable:
Matrix(rw)->show arp
LINK LEVEL ARP TABLE
IP Address Phys Address Flags Interface
-----------------------------------------------------
10.20.1.1 00-00-5e-00-01-1 S host0
134.142.21.194 00-00-5e-00-01-1 S host0
134.142.191.192 00-00-5e-00-01-1 S host0
134.142.192.18 00-00-5e-00-01-1 S host0
134.142.192.119 00-00-5e-00-01-1 S host0
-----------------------------------------------------
Table 12‐1providesanexplanationofthecommandoutput.
show newaddrtraps 12-13
set newaddrtraps 12-14
show movedaddrtrap 12-14
set movedaddrtrap 12-15
For information about... Refer to page...