Enterasys Matrix DFE-Gold Series

set snmp timefilter break Configuring SNMP Walk Behavior
Enterasys Matrix DFE-Gold Series Configuration Guide 5-41
Configuring SNMP Walk Behavior
Purpose
ToconfigureSNMP walkbehavior.
Commands
set snmp timefilter break
UsethiscommandtosetSNMPtoexittheMIBwalkafterthefirstentryitreturnsiftheindex
includesatimestamp.
Syntax
set snmp timefilter break {enable | disable}
Parameters
Defaults
Disabled.
Mode
Switchcommand,Read‐Write.
Usage
Whenanindexcontainsatimestamp,bydefaultthegetNextwalkcontinuestoreturnvaluesuntil
thecurrenttimeisreached,whichmaynoteveroccur,leavingtheuserwiththeimpressionthat
thewalkisinaloop.Enablingthiscommandwillexitthewalkafterthefirstentryis
returned.
Examples
ThisexampleenablestheSNMPtimestampfilterbreakforthisrouter:
Matrix(rw)->set snmp timefilter break enable
For information about... Refer to page...
set snmp timefilter break 5-41
enable ConfigurestheMIBwalkbehaviortoexitafterthefirstentryisreturned
whenthegetNextobjectindexcontainsatimestamp.
disable ConfigurestheMIBwalkbehaviortoonlyexitwhenthecurrenttimeis
reachedwhenthegetNextobjectindexcontainsatimestamp.