Enterasys Matrix DFE-Gold Series

set history Monitoring Network Events and Status
Enterasys Matrix DFE-Gold Series Configuration Guide 11-3
set history
Usethiscommandtosetthesizeofthehistorybuffer.
Syntax
set history size [default]
Parameters
Defaults
Ifdefaultisnotspecified,thehistorysettingwillnotbepersistent.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetthesizeofthecommandhistorybufferto3linesandmakethisthe
defaultsetting:
Matrix(rw)->set history 3 default
show netstat
Usethiscommandtodisplaystatisticsfortheswitch’sactivenetworkconnections.
Syntax
show netstat [icmp | ip | routes | stats | tcp | udp]
Parameters
Defaults
Ifnoparametersarespecified,shownetstatwillbeexecutedasshownintheexamplebelow.
Mode
Switchcommand,Read‐Only.
size Specifiesthesizeofthehistorybufferinlines.Validvaluesare1to100.
default (Optional)Makesthissettingpersistforallfuturesessions.
icmp (Optional)ShowsInternetControlMessageProtocol(ICMP)statistics.
ip (Optional)ShowsInternetProtocol(IP)statistics.
routes (Optional)ShowstheIProutingtable.
stats (Optional)ShowsallstatisticsforTCP,UDP,IP,andICMP.
tcp (Optional)ShowsTransmissionControlProtocol(TCP)statistics.
udp (Optional)ShowsUserDatagramProtocol(UDP)statistics.