Enterasys Matrix DFE-Gold Series

ip rip authentication mode Configuring RIP
Enterasys Matrix DFE-Gold Series Configuration Guide 21-13
ip rip authentication mode
Usethiscommandtosettheauthenticationmodewhenakeychainispresent.
Syntax
ip rip authentication mode {text | md5}
no ip rip authentication mode
Parameters
Defaults
None.
Mode
Routercommand,Interfaceconfiguration:Matrix>Router(config‐if(Vlan1))#
Usage
TheRIPauthenticationkeychainmustbeenabledasdescribedin“ipripauthenticationkeychain”
onpage 21‐12beforeRIPauthenticationmodecanbeconfigured.
The“no”formofthiscommandsuppressestheuseofauthentication.
Example
ThisexampleshowshowtosettheauthenticationmodeforVLAN1as“text”:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip rip authentication mode text
no auto-summary
Usethiscommandtodisableautomaticroutesummarization.
Syntax
no auto-summary
auto-summary
Parameters
None.
Defaults
None.
Mode
Routercommand,Routerconfiguration:Matrix>Router(config‐router)#
text Initiatestext‐onlyauthentication.
md5 InitiatesMD5authentication.