Enterasys Matrix DFE-Gold Series

clear port priority-queue Configuring Priority to Transmit Queue Mapping
Enterasys Matrix DFE-Gold Series Configuration Guide 22-7
Parameters
Defaults
None.
Mode
Read‐Write.
Usage
Thiscommandenablesyoutochangethepriorityqueue(0‐7,dependingonporttype,with0
beingthelowestpriorityqueue)foreachportpriorityoftheselectedport.Youcanapplythenew
settingstooneormoreports.Forexample,ifthepriorityqueueissetto3
forthoseframeswitha
portpriority4,thenthoseframeswouldbetransmittedbeforeanyframescontainedintraffic
classes2through0.
Example
Thisexampleshowshowtosetpriority5framesreceivedonfe.2.12totransmitatthelowest
priorityqueueof0.
Matrix(rw)->set port priority-queue fe.2.12 5 0
clear port priority-queue
Usethiscommandtoresetportpriorityqueuesettingsbacktodefaultsforoneormoreports.
Syntax
clear port priority-queue port-string
Parameters
Defaults
None.
port‐string Specifiestheport(s)forwhichtosetpriorityqueue.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
priority
Specifiesavalueof0‐7(0isthelowestlevel)thatdetermineswhat
priorityframeswillbetransmittedatthepriorityqueuelevelenteredin
thiscommand.
queue
Specifiesavalue(0isthelowestlevel)thatdetermineswhentotransmit
theframeswiththeportpriorityenteredinthiscommand.Numberof
transmitqueuesvariesbyporttype.Typicalvaluesare:
• 100Base‐T‐4
• 1000Base‐T‐4
• 1000Base‐X‐8
port‐string Specifiestheportforwhichtoclearpriorityqueue.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.