Enterasys Matrix DFE-Gold Series

set spantree autoedge Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-29
Example
Thisexampleshowshowtodisplaythestatusoftheautomaticedgeportdetectionfunction:
Matrix(rw)->show spantree autoedge
autoEdge is currently enabled.
set spantree autoedge
Usethiscommandtoenableordisabletheautomaticedgeportdetectionfunction.
Syntax
set spantree autoedge {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtodisableautomaticedgeportdetection:
Matrix(rw)->set spantree autoedge disable
clear spantree autoedge
Usethiscommandtoresetautomaticedgeportdetectiontothedefaultstateofenabled.
Syntax
clear spantree autoedge
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetautomaticedgeportdetectiontoenabled:
Matrix(rw)->clear spantree autoedge
disable|ena ble Disablesorenablesautomaticedgeportdetection.