Enterasys Matrix DFE-Gold Series

clear spantree legacypathcost Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-31
clear spantree legacypathcost
UsethiscommandtosettheSpanningTreedefaultvalueforlegacypathcostto802.1tvalues.
Syntax
clear spantree legacypathcost
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetthedefaultpathcostvaluesto802.1t:
Matrix(rw)->clear spantree legacypathcost
show spantree tctrapsuppress
UsethiscommandtodisplaythestatusoftopologychangetrapsuppressiononRapidSpanning
Treeedgeports.
Syntax
show spantree tctrapsuppress
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythestatusoftopologychangetrapsuppression:
Matrix(rw)->show spantree tctrapsuppress
Topology change trap suppression is currently enabled.