Enterasys Matrix DFE-Gold Series

Configuring RADIUS clear radius accounting
25-58 Authentication Configuration
Defaults
None.
Mode
Switchcommand,Read‐Write.
Examples
ThisexampleshowshowtoenabletheRADIUSaccountingclientforauthenticati ngwiththe
accountingserver1atIPaddress10.2.4.12,UDPauthenticationport1800.Aspreviouslynoted,
the“serversecret”passwordenteredheremustmatchthatalreadyconfiguredastheRead‐Write
(rw)passwordontheRADIUSaccountingserver
Matrix(rw)->set radius accounting server 1 10.2.4.12 1800:
Server Secret:******
Retype Server Secret:******
Make This Entry Active (y/n)? y
Warning: rfc2138 recommends secret minimum length of 16
ThisexampleshowshowtosettheRADIUSaccountingtimeoutto30secondsonserver6:
Matrix(rw)->set radius accounting timeout 30 6
ThisexampleshowshowtosetRADIUSaccountingretriesto10onserver6:
Matrix(rw)->set radius accounting retries 10 6
clear radius accounting
UsethiscommandtoclearRADIUSaccountingconfigurationsettings.
Syntax
clear radius accounting {[server{index | all}] [retries {index | all}] [timeout
{index | all}] [intervalminimum] [updateinterval]}
Parameters
index|all AppliesthesettingstoaspecificRADIUSaccountingserverortoall.
serverip _addressport
server‐secret
Specifiestheaccountingserver’s:
•IPaddress
•UDPauthenticationport(0‐65535)
• server‐secret(Read‐Writepasswordtoaccessthisaccountingserver.
Devicewillpromptforthisentryuponcreatingaserverinstance,as

shownintheexamplebelow.)
serverindex|all Clearstheconfigurationononeormoreaccountingservers.
retriesindex|all Resetstheretriestothedefaultvalueof2ononeormoreaccounting
servers.
timeoutindex|all Resetsthetimeoutto5secondsononeormoreaccountingservers.
intervalminimum Resetstheminimuminterval
to600seconds.
updateinterval Resetstheupdateintervalto1800seconds.