Enterasys Matrix DFE-Gold Series

Configuring Simple Network Time Protocol (SNTP) clear sntp client
13-4 SNTP Configuration
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoenableSNTPinbroadcastmode:
Matrix(rw)->set sntp client broadcast
clear sntp client
UsethiscommandtocleartheSNTPclient’soperationalmode.
Syntax
clear sntp client
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtocleartheSNTPclient’soperationalmode:
Matrix(rw)->clear sntp client
set sntp server
UsethiscommandtoaddaserverfromwhichtheSNTPclientwillretrievethecurrenttimewhen
operatinginunicastmode.Upto10serverscanbesetasSNTPservers.
Syntax
set sntp server ip-address [precedence]
Parameters
Defaults
Ifprecedenceisnotspecified,1willbeapplied.
Mode
Switchcommand,Read‐Write.
ip‐address SpecifiestheSNTPserver’sIPaddress.
precedence (Optional)Specifies thisSNTPserver’sprecedenceinrelationtoits
peers.Validvaluesare1(highest)to10(lowest).