Enterasys Matrix DFE-Gold Series User Manual

show ip ospf border-routers Configuring OSPF
Enterasys Matrix DFE-Gold Series Configuration Guide 21-45
show ip ospf border-routers
UsethiscommandtodisplayinformationaboutOSPFinternalentriestoAreaBorderRouters
(ABRs)andAutonomousSystemBoundaryRouters(ASBRs).
Syntax
show ip ospf border-routers
Parameters
None.
Defaults
None.
Mode
Routercommand,Anyroutermode.
Example
ThisexampleshowshowtodisplayinformationaboutOSPFborderrouters.Thefirstlineofthis
outputshowsthatanintra‐arearoutehasbeenestablishedtodestinationborderrouter
192.168.22.1vianeighboringrouter192.16 8.11.1ontheVLAN2interfaceinarea0.TheOSPFcost
ofthisrouteis64,
anditcarriesanSPFcalculationof10.ThedestinationrouterisanABR:
Matrix>Router#show ip ospf border-routers
OSPF internal
Codes: i - Intra-area route, I - Inter-area route
i 192.168.22.1 [64] via 192.168.11.1, VLAN2, ABR, Area 0, SPF 10
i 192.168.22.1 [64] via 192.168.11.1, VLAN2, ABR, Area 4, SPF 10
i 192.168.44.1 [64] via 192.168.33.1, VLAN1, ABR, Area 0, SPF 10
i 192.168.44.1 [64] via 192.168.33.1, VLAN1, ABR, Area 2, SPF 7
i 192.168.44.2 [128] via 192.168.33.1, VLAN1, ABR, Area 0, SPF 10
i 192.168.44.2 [128] via 192.168.11.1, VLAN2, ABR, Area 0, SPF 10
show ip ospf interface
UsethiscommandtodisplayOSPFinterfacerelatedinformation,includingnetworktype,priority,
cost,hellointerval,anddeadinterval.
Syntax
show ip ospf interface [vlan vlan-id]
Checksum Field in the link state record used to verify the contents upon receipt by
another router.
LinkCount Link count of router link state records. This number is equal to, or
greater than, the number of active OSPF interfaces on the originating
router.
Table 21-3 show ip ospf database Output Details (continued)
Output... What it displays...

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English