Enterasys Matrix DFE-Gold Series

show spantree fwddelay Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-27
Example
Thisexampleshowshowtogloballyresetthemaximumagingtime:
Matrix(rw)->clear spantree maxage
show spantree fwddelay
UsethiscommandtodisplaytheSpanningTreeforwarddelaytime.
Syntax
show spantree fwddelay
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheSpanningTreeforwarddelaytime:
Matrix(rw)->show spantree fwddelay
Bridge Forward Delay is set to 15 seconds
set spantree fwddelay
UsethiscommandtosettheSpanningTreeforwarddelay.
Syntax
set spantree fwddelay delay
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
SpanningTreeforwarddelayisthemaximumtime(inseconds)therootdevicewillwaitbefore
changingstates(thatis,listeningtolearningtoforwarding).Thisdelayisrequiredbecauseevery
devicemustreceiveinformationabouttopologychangesbeforeitstartstoforwardframes.In
delay
Specifiesthenumberofsecondsforthebridgeforwarddelay.Valid
valuesare4‐30.