Enterasys Matrix DFE-Gold Series

clear cep Configuring Convergence End Points (CEP) Phone Detection
Enterasys Matrix DFE-Gold Series Configuration Guide 25-49
clear cep
Usethiscommandtoclearconvergenceendpointsparameters.
Syntax
clear cep {all | policy | detection [detection-id] | users [port-string] | port
[port-string {all | cisco | h323 | siemens |sip} ] }
Parameters
Defaults
Ifnodetection‐idisspecified,allCEPdetectiongroupsarereturnedtothedefaultconfiguration.
Ifnoport‐stringisspecifiedwiththeusersparameter,alldiscoveredConvergenceEndpointsare
cleared.
Ifnoport‐stringisspecifiedwiththeportparameter,allportsarecleared.
Mode
Switchcommand,Read‐Write.
Examples
ThisexampleshowshowtoclearallCEPpolicyparameters
Matrix>clear cep policy
Thisexampleshowshowtocleardetectionid4parameters
Matrix>clear cep detection-id 4
Thisexampleshowshowtoclearsportsfe.1.1‐5ofCiscophonedetectionparameters
Matrix>clear cep port fe.1.1-5 cisco
all RestoresfactorydefaultstoallCEPconfigurationinformation.
policy RestorefactorydefaultstoCEPpolicyconfiguration.
detection[detection‐id]RestorefactorydefaultstoCEPdetectiongroupconfiguration.
Optionally,specifyaparticularCEPconfigurationgrouptoclearwith
detection‐id.Validvaluesare1‐2147483647.
users[port‐string]CleardiscoveredConvergence
Endpoints.Optionally,specifyoneor
moreport(s)onwhichtocleardiscoveredCEPs.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
port[port‐string{all|
cisco|h323|siemens
|sip}]
ResetstheCEP
enabledstatetothedefaultofdisabled.Optionally,
specifyoneormoreport(s)todisableand specifyalldetectiontypesor
individualdetectiontypestodisable.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage 4‐2.