Configuring Port Traffic Rate Limiting set port ratelimit
22-10 Port Priority and Rate Limiting Configuration
----------- ----- --------- ------------ --------- ----------- --------
fe.2.1 1 64125 discard inbound 0 disabled
fe.2.1 2 64125 discard inbound 0 disabled
fe.2.1 3 64125 discard inbound 0 disabled
fe.2.1 4 64125 discard inbound 0 disabled
fe.2.1 5 64125 discard inbound 0 disabled
fe.2.1 6 64125 discard inbound 0 disabled
fe.2.1 7 64125 discard inbound 0 disabled
fe.2.1 8 64125 discard inbound 0 disabled
fe.2.1 9 64125 discard inbound 0 disabled
fe.2.1 10 64125 discard inbound 0 disabled
fe.2.1 11 64125 discard inbound 0 disabled
fe.2.1 12 64125 discard inbound 0 disabled
Table 22‐1showsadetailedexplanationofthecommandoutput.
set port ratelimit
Usethiscommandtoconfigurethetrafficratelimitingstatusandthreshold(inkilobytesper
second)foroneormoreports.
Syntax
set port ratelimit {disable | enable} | port-string priority threshold {disable |
enable} [inbound] [index]
Parameters
Table 22-1 show port ratelimit Output Details
Output... What it displays...
Port Number Port designation. For a detailed description of possible port-string
values, refer to “Port String Syntax Used in the CLI” on page 4-2.
Index Resource index for this port.
Threshold (kB/s) Port rate limiting threshold in kilobytes per second.
Action Whether or not frames not conforming to rate limiting will be discarded.
Direction This rule applies to inbound traffic.
Priority List 802.1D (802.1p) port priority level.
Status Whether or not this rule is active or disabled.
disable|enable Whenenteredwithoutaport‐string,globallydisablesorenablestheport
ratelimitingfunction.Whenenteredwithaport‐string,disablesor
enablesratelimitingonspecificport(s)whentheglobalfunctionis
enabled.
port‐string Specifiesaportonwhichtosettheratelimitingthreshold
andother
parameters.Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedintheCLI”onpage 4‐2.