Enterasys Matrix DFE-Gold Series

Configuring Convergence End Points (CEP) Phone Detection set cep detection-id address
25-46 Authentication Configuration
set cep detection-id address
UsethiscommandtosetanH.323,Siemens,orSIPphonedetectiongroup’sIPaddressormask.
Syntax
set cep detection-id id address { ip-address | unknown }
mask {mask | unknown }
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
ThiscommandappliesonlytoSiemens,H.323,andSIPphonedetection.Ciscodetectionuses
CiscoDPasitsdiscoverymethod.
Bydefault,H.323willuse224.0.1.41asitsIPaddressandSiemenswillhavenoIPaddress
configured.
Example
ThisexampleshowshowtosetanIPaddressof10.1.1.3andmaskfordetectiongroup1:
Matrix>set cep detection-id 1 address 10.1.1.3 mask 255.255.0.0
set cep detection-id protocol
UsethiscommandtospecifyanIPprotocoltypeforH.323,Siemens,orSIPconvergenceend
pointsdetection.
Syntax
set cep detection-id id protocol {tcp | udp | both | none}
id Specif iesaCEPconfigurationgroupID.Thisgroupmustbecreated
andenabledusingthesetcepdetection‐idcommandasdescribedin
“setcepdetection‐id”onpage 25‐44.Validvaluesare1‐2147483647.
addressip‐address|
unknown
SetstheIPaddressforCEPdetection,orsets
theaddresstounknown.
maskmask|
unknown
SettheIPmaskforCEPdetection,orsetsthemasktounknown.