Enterasys Matrix DFE-Gold Series User Manual

clear ip ospf process Configuring OSPF
Enterasys Matrix DFE-Gold Series Configuration Guide 21-49
Hello 10, Dead 40, Wait 40, Retransmit 5
Adjacency State FULL
Table 21‐6providesanexplanationofthecommandoutput.
clear ip ospf process
UsethiscommandtoresettheOSPFprocess.
Syntax
clear ip ospf process process-id
Parameters
Defaults
None.
Mode
Routercommand,PrivilegedEXEC:Matrix>Router#
Usage
Thiscommandwillrequireadjacenciestobereestablishedandroutestobereconverged.
Example
ThisexampleshowshowtoresetOSPFprocess1:
Matrix>Router#clear ip ospf process 1
Table 21-6 show ip ospf virtual links Output Details
Output... What it displays...
Virtual Link ID of the virtual link neighbor, and the virtual link status, which is up or
down.
Transit area ID of the transit area through which the virtual link is configured.
via interface Router’s interface into the transit area.
Cost of using OSPF cost of routing through the virtual link.
Transit Delay Time (in seconds) added to the LSA (Link State Advertisement) age
field when the LSA is transmitted through the virtual link.
State Interface state assigned to a virtual link, which is point-to-point.
Timer intervals configured Timer intervals configured for the virtual link, including Hello, Dead,
Wait, and Retransmit intervals.
Adjacency State State of adjacency between this router and the virtual link neighbor of
this router.
process‐id Specifies theprocessID,aninternallyusedidentificationnumberfor
eachinstanceoftheOSPFroutingprocessrunonarouter.Validvalues
are1to65535.

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English