Enterasys Matrix DFE-Gold Series

clear spantree porthello Configuring Spanning Tree Port Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-57
Usage
Thiscommandcanbeexecutedonlyifbridgehellomodeisdisabled.Forinformationonusingthe
setspantreebridgehellomodecommand,referto“setspantreebridgehellomode”onpage 6‐23.
Example
Thisexampleshowshowtosetthehellotimeto3secondsforportfe.1.4:
Matrix(rw)->set spantree porthello fe.1.4 3
clear spantree porthello
UsethiscommandtoresetthehellotimeforoneormoreSpanningTreeportstothedefaultof2
seconds.
Syntax
clear spantree porthello port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthehellotimeto2secondsforportfe.1.4:
Matrix(rw)->clear spantree porthello fe.1.4
show spantree portcost
UsethiscommandtodisplaycostvaluesassignedtooneormoreSpanningTreeports.
Syntax
show spantree portcost [port port-string] [sid sid]
Parameters
Defaults
•Ifport‐stringisnotspecified,portcostwillbedisplayedforallSpanningTreeports.
port‐string Specifiestheport(s)forwhichtoresethellotime.
portport‐string (Optional)Displayscostvaluesforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
sidsid (Optional)DisplaysportcostforaspecificSpanningTreeidentifier.
Validvaluesare0‐4094.Ifnot
specified,SID0willbeassumed.