Enterasys Matrix DFE-Gold Series User Manual

show ciscodp port info Cisco Discovery Protocol
Enterasys Matrix DFE-Gold Series Configuration Guide 3-9
Device ID : 00E06314BD57
Last Change : WED FEB 08 01:07:45 2006
Table 3‐2providesanexplana tion ofthecommandoutput.
show ciscodp port info
UsethiscommandtodisplaysummaryinformationabouttheCiscoDiscoveryProtocolononeor
moreports.
Syntax
show ciscodp port info [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,CiscoDPinformationwillbedisplayedforallports.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplayCiscoDiscoveryProtocolinformationforportsfe.1.1through
fe.1.5:
Matrix>(su)->show ciscodp port info fe.1.1-5
port state vvid trust cos
-----------------------------------------------
Table 3-2 show ciscodp Output Details
Output... What it displays...
CiscoDP Whether Cisco Discovery Protocol is disabled or enabled globally. Auto
indicates that Cisco DP will be globally enabled only if Cisco DP PDUs
are received. Default setting of auto can be changed with the set
ciscodp status command as described in “set ciscodp status” on
page 3-10.
Timer Number of seconds between Cisco Discovery Protocol PDU
transmissions. Default value of 60 can be changed with the set
ciscodp timer command as described in “set ciscodp timer” on
page 3-11.
Holdtime (TTL) Number of seconds neighboring devices will hold PDU transmissions
from the sending device. Default value of 180 can be changed with the
set ciscodp holdtime command as described in “set ciscodp
holdtime” on page 3-11.
Device ID The MAC address of the switch.
Last Change The time that the last Cisco DP neighbor was discovered.
port‐string (Optional)Displaysinformationaboutspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English