Enterasys Matrix DFE-Gold Series - Show Tacacs Command

Configuring TACACS+ show tacacs command
25-70 Authentication Configuration
Defaults
Atleastoneoftheses si o n a uthorizationparametersmustbespecified.
Mode
Switchcommand,Read‐Write.
Examples
Thisexampleshowshowtoreturnonlytheservicenametothedefaultof“exec.”
Matrix(rw)->clear tacacs session authorization service
Thisexampleshowshowtoreturnallthesessionauthorizationparameterstotheirdefaultvalues.
Matrix(rw)->clear tacacs session authorization service read-only read-write
super-user
show tacacs command
Usethiscommandtodisplaythestatus(enabledordisabled)ofTACACS+accountingor
authorizationonaper‐commandbasis.
Syntax
show tacacs command {accounting | authorization} [state]
Parameters
Defaults
Ifstateisnotspecified,allaccountingorauthorizationconfigurationparametersaredisplayed
(whichatthistimeincludesonlytheenabled/disabledstatus).
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtodisplaythestateofthe TACACS+client’s commandauthorization.
Matrix(rw)->show tacacs command authorization
TACACS+ command authorization state: enabled
accounting Displaythestatus ofTACACS+accountingonaper‐commandbasis.
authorization DisplaythestatusofTACACS+authorizationonaper‐commandbasis.
state (Optional)Specifiesthatonlythestatusshouldbedisplayed.