Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters show spantree hello
6-24 Spanning Tree Configuration
Example
ThisexampleshowshowtoresettheSpanningTreebridgehellomodetoenabled:
Matrix(rw)->clear spantree bridgehellomode
show spantree hello
UsethiscommandtodisplaytheSpanningTreehellotime.
Syntax
show spantree hello
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheSpanningTreehellotime:
Matrix(rw)->show spantree hello
Bridge Hello Time is set to 2 seconds
set spantree hello
Usethiscommandtosetthedevice’sSpanningTreehellotime.
Syntax
set spantree hello interval
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Thisisthetimeinterval(inseconds)thedevicewilltransmitBPDUsindicatingitisactive.
interval Specifiesthenumberofsecondsthesystemwaitsbeforebroadcastinga
bridgehellomessage(amulticastmessageindicatingthatthesystemis
active).Validvaluesare1‐10.