Enterasys Matrix DFE-Gold Series

set snmp notify Configuring SNMP Notification Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 5-35
set snmp notify
UsethiscommandtosettheSNMPnotifyconfiguration.
Syntax
set snmp notify notify tag tag [trap | inform] [volatile | nonvolatile]
Parameters
Defaults
•Ifnotspecified,messagetypewillbesettotrap.
•Ifnotspecified,storagetypewillbesettononvolatile.
Mode
Switchcommand,Read‐Write.
Usage
ThiscreatesanentryintheSN MPnotifytable,whichisusedtoselectmanagementtargetswho
shouldreceivenotificationmessages.Thiscommand’stagparametercanbeusedtobindeach
entrytoatargetaddressusingthesetsnmptargetaddr command(“setsnmptargetaddr”on
page 5‐30).
Example
ThisexampleshowshowtosetanSNMPnotifyconfigurationwithanotifynameof“hello”anda
notifytagof“world”.Notificationswillbesentastrapmessagesandstoragetypewill
automaticallydefaulttopermanent:
Matrix(rw)->set snmp notify hello tag world trap
clear snmp notify
UsethiscommandtoclearanSNMPnotifyconfiguration.
Syntax
clear snmp notify notify
Parameters
notify SpecifiesanSNMPnotifyname.
tagtag SpecifiesanSNMPnotifytag.ThisbindsthenotifynametotheSNMP
targetaddresstable.
trap|inform (Optional)SpecifiesSNMPv1orv2Trapmessages(default)orSNMPv3
InformRequestmessages.
volatile|nonvolatile (Optional)Specifiestemporary(default),orpermanentstoragefor
SNMPentries.
notify SpecifiesanSNMPnotifynametoclear.