Enterasys Matrix DFE-Gold Series

clear logging application Configuring System Logging
Enterasys Matrix DFE-Gold Series Configuration Guide 10-11
clear logging application
Usethiscommandtoresettheloggingseveritylevelforoneorallapplicationstothedefaultvalue
of6(notificationsofsignificantconditions).
Syntax
clear logging application {mnemonic | all}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresettheloggi ngseveritylevelforSSH:
Matrix(rw)->clear logging application SSH
show logging local
Usethiscommandtodisplaythestateofmessageloggingtotheconsoleandapersistentfile.
Syntax
show logging local
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythestateofmessagelogging.Inthiscase,loggingtothe
consoleisenabledandloggingtoapersistentfileisdisabled.
Matrix(rw)->show logging local
Syslog Console Logging enabled
Syslog File Logging disabled
mnemonic|all (Optional)Resetstheseveritylevelforaspecificapplicationorforall
applications.Validmnemonicvaluesandtheircorresponding
applicationsarelistedinTable 10‐3.