Enterasys Matrix DFE-Gold Series

set snmp notifyfilter Configuring SNMP Notification Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 5-37
set snmp notifyfilter
UsethiscommandtocreateanSNMPnotifyfilterconfiguration.
Syntax
set snmp notifyfilter profile subtree oid-or-mibobject [mask mask] [included |
excluded] [volatile | nonvolatile]
Parameters
Defaults
•Ifnotspecified,maskisnotset.
•Ifnotspecified,subtreewillbeincluded.
•Ifstoragetypeisnotspecified,nonvolatile(permanent)willbeapplied.
Mode
Switchcommand,Read‐Write.
Usage
ThisidentifieswhichmanagementtargetsshouldNOTreceivenotificationmessages,whichis
usefulforfine‐tuningtheamountofSNMPtrafficgenerated.
Example
ThisexampleshowshowtocreateanSNMPnotifyfiltercalled“pilot1”withaMIBsubtreeIDof
1.3.6:
Matrix(rw)->set snmp notifyfilter pilot1 subtree 1.3.6
clear snmp notifyfilter
UsethiscommandtodeleteanSNMPnotifyfilterconfiguration.
Syntax
clear snmp notifyfilter profile subtree oid-or-mibobject
Parameters
profile SpecifiesanSNMPfilternotifyname.
subtreeoid‐or‐
mibobject
SpecifiesaMIBsubtreeIDtargetforthefilter.
maskmask (Optional)Appliesasubtreemask.
included|excluded (Optional)Specifiesthatsubtreeisincludedorexcluded.
volatile|nonvolatile (Optional)Specifiesastoragetype.
profile SpecifiesanSNMPfilternotifynametodelete.
subtreeoid‐or‐
mibobject
SpecifiesaMIBsubtreeIDcontainingthefiltertobedeleted.