Enterasys Matrix DFE-Gold Series

set garp timer Enabling/Disabling GVRP
Enterasys Matrix DFE-Gold Series Configuration Guide 7-27
Example
ThisexampleshowshowtoclearGVRPstatusgloballyonthedevice:
Matrix(rw)->clear gvrp
set garp timer
Usethiscommandtoadjustthevaluesofthejoin,leave,andleavealltimers.
Syntax
set garp timer {[join timer-value] [leave timer-value] [leaveall timer-value]}
port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Thesettingofthesetimersiscriticalandshouldonlybechangedby personnelfamiliarwiththe
802.1Qstandardsdocumentation,whichisnotsuppliedwiththisdevice.
Examples
ThisexampleshowshowtosettheGARPjointimervalueto100centisecondsforallports:
Matrix(rw)->set garp timer join 100 *.*.*
Thisexampleshowshowtosettheleavetimervalueto300centisecondsforallports:
Matrix(rw)->set garp timer leave 300 *.*.*
Thisexampleshowshowtosettheleavealltimervalueto20000centisecondsforallports:
Matrix(rw)->set garp timer leaveall 20000 *.*.*
clear garp timer
UsethiscommandtoresetGARPtimersbacktodefaultvalues.
Syntax
clear garp timer {[join] [leave] [leaveall]} port-string
jointimer‐value SetstheGARPjointimerincentiseconds(Referto802.1Qstandard.)
leavetimer‐value SetstheGARPleavetimerincentiseconds(Referto802.1Qstandard.)
leavealltimer‐value SetstheGARPleavealltimerincentiseconds(Referto802.1Qstandard.)
port‐string Specifiestheport(s)onwhichtoconfigureGARPtimersettings.
Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.