Enterasys Matrix DFE-Gold Series User Manual

Startup and General Configuration Summary
Enterasys Matrix DFE-Gold Series Configuration Guide 2-5
VLAN ID All ports use a VLAN identifier of 1.
WebView (HTTP) Enabled on TCP port 80.
Table 2-2 Default Device Settings for Router Mode Operation
Device Feature Default Setting
Access groups (IP security) None configured.
Access lists (IP security) None configured.
Area authentication
(OSPF)
Disabled.
Area default cost (OSPF) Set to 1.
Area NSSA (OSPF) None configured.
Area range (OSPF) None configured.
ARP table No permanent entries configured.
ARP timeout Set to 14,400 seconds.
Authentication key (RIP
and OSPF)
None configured.
Authentication mode (RIP
and OSPF)
None configured.
Dead interval (OSPF) Set to 40 seconds.
Disable triggered updates
(RIP)
Triggered updates allowed.
Distribute list (RIP) No filters applied.
DoS prevention Disabled.
DVMRP Disabled. Metric set to 1.
Hello interval (OSPF) Set to 10 seconds for broadcast and point-to-point networks. Set to 30
seconds for non-broadcast and point-to-multipoint networks.
ICMP Enabled for echo-reply and mask-reply modes.
IP-directed broadcasts Disabled.
IP forward-protocol Enabled with no port specified.
IP interfaces Disabled with no IP addresses specified.
IRDP Disabled on all interfaces. When enabled, maximum advertisement interval is
set to 600 seconds, minimum advertisement interval is set to 450 seconds,
holdtime is set to 1800 seconds, and address preference is set to 0.
MD5 authentication
(OSPF)
Disabled with no password set.
MTU size Set to 1500 bytes on all interfaces.
OSPF Disabled.
OSPF cost Set to 10 for all interfaces.
OSPF network None configured.
Table 2-1 Default Device Settings for Basic Switch Operation (continued)
Device Feature Default Setting

Enterasys Matrix DFE-Gold Series Specifications

General

Brand	Enterasys
Model	Matrix DFE-Gold Series
Category	Switch
Language	English