Startup and General Configuration Summary
2-4 Startup and General Configuration
Spanning Tree edge port
delay
Enabled.
Spanning Tree forward
delay
Set to 15 seconds.
Spanning Tree hello
interval
Set to 2 seconds.
Spanning Tree ID (SID) Set to 0.
Spanning Tree legacy path
cost
Disabled.
Spanning Tree maximum
aging time
Set to 20 seconds.
Spanning Tree point-to-
point
Set to auto for all Spanning Tree ports.
Spanning Tree port priority All ports with bridge priority are set to 128 (medium priority).
Spanning Tree priority Bridge priority is set to 32768.
Spanning Tree topology
change trap suppression
Enabled.
Spanning Tree transmit
hold count
Set to 3.
Spanning Tree version Set to mstp (Multiple Spanning Tree Protocol).
Spanning Tree Loop
Protect
Disabled per port and per SID.
Spanning Tree Loop
Protect event threshold
3 events.
Spanning Tree Loop
Protect event window
180 seconds.
Spanning Tree Loop
Protect traps
Disabled.
Spanning Tree disputed
BPDU threshold
Set to 0, meaning no traps are sent.
SSH Disabled.
System baud rate Set to 9600 baud.
System contact Set to empty string.
System location Set to empty string.
System name Set to empty string.
Terminal CLI display set to 80 columns and 24 rows.
Timeout Set to 15 minutes.
User names Login accounts set to ro for Read-Only access; rw for Read-Write access;
and admin for Super User access.
VLAN dynamic egress Disabled on all VLANs.
Table 2-1 Default Device Settings for Basic Switch Operation (continued)
Device Feature Default Setting
To Next Page
Loading...
Need help?
General