Enterasys Matrix DFE-Gold Series

clear flowlimit action Configuring Flow Setup Throttling (FST)
Enterasys Matrix DFE-Gold Series Configuration Guide 24-29
Defaults
•Ifactionisnotspecified,noactionwillbeapplied.
•Ifclassificationporttypeisnotspecified,nonewillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetflowlimitingaction1todiscardallflowsexceedingflowlimit1on
portsclassifiedasuserports:
Matrix(rw)->set flowlimit action 1 discard userport
clear flowlimit action
Usethiscommandtoremoveaflowlimitingactionconfiguration.
Syntax
clear flowlimit {action1 | action2} [notify] [drop] [disable] [userport |
serverport | aggregateduser | interswitchlink | unspecified]
Parameters
drop (Optional)Whenflowlimitisreached,dropsexcessflowsanddiscard
packets.
disable (Optional)Whenflowlimitisreached,disablestheinterface(iftheset
flowlimitshutdownfunctionisenabledasdescribedin“setflowlimit
shutdown”onpage 24‐32).ThiswillclearallFSTsettingsontheport.
userport|
serverport
|aggregateduser|
interswitchlink|
unspecified
(Optional)Assignsthisactionconfigurationtotheuserclassification
porttype:
•userport
•serverport
•aggregationport
•inter‐switchlink
•unspecifiedport
action1|action2 Specifiestheconfigurationtoberemovedasaction1or2.
notify (Optional)Removesthenotifyaction.
drop (Optional)Removesthedropaction.