Enterasys Matrix DFE-Gold Series

Setting Basic Device Properties set physical assetid
2-56 Startup and General Configuration
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplayassetIDinformationformodule1.Inthiscase,nonehasbeen
configured:
Matrix(rw)->show physical assetid module 1
module-1 assetID=<empty string> entity=71
set physical assetid
UsethiscommandtosettheassetIDforamodule.
Syntax
set physical assetid module module string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosettheassetIDinformationformodule1to“dfe1”:
Matrix(rw)->set physical assetid module 1 dfe1
clear physical assetid
UsethiscommandtoresettheassetIDforamoduletoazero‐lengthstring.
Syntax
clear physical assetid module module
modulemodule SpecifiesthemoduleforwhichtodisplayanassetID.
modulemodule SetsanassetIDforaspecificmodule.
string SpecifiestheassetID.