Enterasys Matrix DFE-Gold Series

set spantree maxhops Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-35
set spantree maxhops
UsethiscommandtosettheSpanningTreemaximumhopcount.
Syntax
set spantree maxhops max_hop_count
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
SpanningTreemaximumhopcountisthemaximumnumberofhopsthattheinformationfora
particularSpanningTreeinstancemaytraverse(viarelayofBPDUswithintheapplicableMST
region)beforebeingdiscarded.
Example
Thisexampleshowshowtosetthemaximumhopcountto40:
Matrix(rw)->set spantree maxhops 40
clear spantree maxhops
Usethiscommandtoresetthemaximumhopcounttothedefaultvalueof20.
Syntax
clear spantree maxhops
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthemaximumhopcountto20:
Matrix(rw)->clear spantree maxhops
max_hop_count Specifiesthemaximumnumberofhopsallowed.Validvaluesare0to
255.Defaultvalueis20.