Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters show spantree priority
6-20 Spanning Tree Configuration
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthebridgeprioritymodeto802.1t:
Matrix(rw)->clear spantree bridgeprioritymode
show spantree priority
UsethiscommandtodisplaytheSpanningTreebridgepriority.
Syntax
show spantree priority [sid]
Parameters
Defaults
Ifsidisnotspecified,prioritywillbeshownforSpanningTree0.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtoshowthebridgepriorityforSpanningTree0
Matrix(rw)->show spantree priority
Bridge Priority is set to 4096 on sid 0
set spantree priority
Usethiscommandtosetthedevice’sSpanningTreepriority.
Syntax
set spantree priority priority [sid]
sid (Optional)DisplaysthepriorityforaspecificSpanningTree.Valid
valuesare0‐4094.Ifnotspecified,SID0isassumed.