Enterasys Matrix DFE-Gold Series

set radius-snooping flow Understanding RADIUS Snooper
Enterasys Matrix DFE-Gold Series Configuration Guide 26-5
Example
ThisexampleenablesRSonportsge.1.10throughge.1.15,sets thetimeoutto15secondsand
enablesdrop:
Matrix(rw)->set radius-snooping enable timeout 15 drop enable ge.1.10-15
set radius-snooping flow
UsethiscommandtoprovidefortheenteringofRADIUSclientandserversessionflowentries
intotheRSflowtable.
Syntax
set radius-snooping flow index client-IP-Address server-IP-Address {port |
standard} [secret]
Parameters
Defaults
Ifnosecretisspecified,nosecretisusedforthisflowentry.
Mode
Read‐write.
Usage
RADIUSflowsdefinedintheRSflowtablearesnoopedifRSisenabledforboththesystemand
thisport.
Flowentriesareaddedtotheflowtablebasedupontheentryindexvalue.Thefirstmatching
entryinthetableistheentryusedforthecontinuationofthe
authenticationprocess.
Ifasecretisconfiguredontheauthenticationserverandnotconfiguredhere,novalidationwill
occur.
Example
Thisexamplecreatesanindex1entryintheRADIUSflowtableforclient192.10.5.10andserver
192.10.20.1forthe standardUPDport1812withasecretmysecret:
Matrix(rw)->set radius-snooping flow 1 192.10.5.10 192.10.20.1 standard mysecret
index SpecifiesanumericindexIDforthisflowtableentry.
client‐IP‐Address SpecifiestheclientIPaddressforthisRSflowtable entry.
server‐IP‐Address SpecifiestheserverIPaddressforthisRSflowtableentry.
port SpecifiestheRADIUSUDPporttouseforthisRSflowtableentry.
standard Specifies
RADIUSUDPstandardport1812.
secret SpecifiestheRADIUSsecretforthisRSflowtableentry.