Enterasys Matrix DFE-Gold Series

Configuring RMON set rmon host properties
11-28 Network Monitoring Configuration
Out Octets 136
Broadcast Pkts 0
Multicast Pkts 0
set rmon host properties
UsethiscommandtoconfigureanRMONhostentry.
Syntax
set rmon host properties index port-string [owner]
Parameters
Defaults
Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoconfigureRMONhostentry1onFastEthernetport5inmodule1:
Matrix(rw)->set rmon host properties 1 fe.1.5
set rmon host status
UsethiscommandtoenableanRMONhostentry.
Syntax
set rmon host status index enable
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
index Specifiesanindexnumberforthisentry.Anentrywillautomaticallybe
createdifanunusedindexnumberischosen.Maximumnumberof
entriesis5.Maximumvalueis65535.
port‐string ConfiguresRMONhostmonitoringonaspecificport. 
owner (Optional)Specifiesthenameofthe
entitythatconfiguredthisentry.
index Specifiesanindexnumberforthisentry.Maximumnumberofentriesis
5.Maximumvalueis65535.
enable Enablesthishostentry.