Enterasys Matrix DFE-Gold Series

show igmp number-groups Configuring IGMP
Enterasys Matrix DFE-Gold Series Configuration Guide 9-17
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheIGMPcounters:
Matrix(rw)->show igmp counters
Igmp Counters:
Igmp Group Table is Full : false
Igmp Version 1 Queries transmitted : 0
Igmp Version 2 Queries transmitted : 1016368
Igmp Version 3 Queries transmitted : 0
Igmp Group Specific Queries transmitted : 0
Igmp Queries received : 776482
Igmp Version 1 Joins received : 0
Igmp Version 2 Joins received : 1024
Igmp Version 3 Joins received : 22
Igmp Leave Groups received : 0
Igmp Dropped Frames : 22
Usage
show igmp number-groups
UsethiscommandtodisplaythenumberofmulticastgroupssupportedbytheEnterasysMatrix
device.
Syntax
show igmp number-groups
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐write.
Usage
Thecommanddisplaysboththecurrentlyactivenumberofgroupsandtheconfigurednumber
thatwilltakeeffectatthenextreboot.