Enterasys Matrix DFE-Gold Series

set system utilization threshold Setting Basic Device Properties
Enterasys Matrix DFE-Gold Series Configuration Guide 2-39
Router OSPF 40 0.0% 0.0% 0.0%
Router RIP 41 0.0% 0.0% 0.0%
Router VRRP 42 0.0% 0.0% 0.0%
Router DVMRP 43 0.0% 0.0% 0.0%
Router PIM 44 0.0% 0.0% 0.0%
Router PIMDM 45 0.0% 0.0% 0.0%
Router ARP 46 0.0% 0.0% 0.0%
Router LSNAT 47 0.0% 0.0% 0.0%
Interrupts 48 0.0% 0.0% 0.0%
OTHER 49 0.0% 0.0% 0.0%
IDLE 50 96.4% 97.0% 97.0%
Storage Utilization:
Slot: 1
Type Description Size (Kb) Available (Kb)
-----------------------------------------------------------------
RAM RAM device 1 131072 22192
Flash Images & Miscellaneous 16384 4138
Flash Nonvolatile Data Storage 16384 14308
set system utilization threshold
UsethiscommandtosetthethresholdforsendingCPUutilizationnotificationmessages.
Syntax
set system utilization threshold threshold
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Thevaluerangeis[1..1000]andrepresentsthe%ofsystemutilizationtouseasthetrapthreshold.
Example
Thisexampleshowshowtosetthesystemutilizationthresholdto100%:
Matrix(rw)->set system utilization threshold 1000
threshold Specifiesathresholdvalue(in1/10ofapercent).Validrangeis1‐1000.
Avalueof0willdisableutilizationnotificationmessages.