Enterasys Matrix DFE-Gold Series

show spantree mstmap Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-15
show spantree mstmap
UsethiscommandtodisplaythemappingofafilteringdatabaseID(FID)toaSpanningTrees.
SinceVLANsaremappedtoFIDs,thisshowstowhichSIDaVLANismapped.
Syntax
show spantree mstmap [fid fid]
Parameters
Defaults
Iffidisnotspecified,informationforallassignedFIDswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaySIDtoFIDmappinginf ormationforFID1.Inthiscase,no
newmappingshavebeenconfigured:
Matrix(rw)->show spantree mstmap fid 1
FID: SID:
1 0
set spantree mstmap
UsethiscommandtomaponeormorefilteringdatabaseIDs(FIDs)toaSID.SinceVLANsare
mappedtoFIDs,thisessentiallymapsoneormoreVLANIDstoaSpanning Tree(SID).
Syntax
set spantree mstmap fid [sid sid]
Parameters
Defaults
Ifsidisnotspecified,FID(s)willbemappedtoSpanningTree0.
Mode
Switchcommand,Read‐Write.
fidfid (Optional)DisplaysinformationforspecificFIDs.
fid SpecifiesoneormoreFIDstoassigntotheMST.Validvaluesare1‐
4093,andmustcorrespondtoaVLANIDcreatedusingthesetvlan
commandasdescribedin“setvlan”onpage 7‐6.
sidsid (Optional)SpecifiesaMultipleSpanningTreeID.Validvaluesare1
‐
4094,andmustcorrespondtoaSIDcreatedusingthesetmsti
commandasdescribedin“setspantreemsti”onpage 6‐14.