Enterasys Matrix DFE-Gold Series - Enable

enable Configuring VRRP
Enterasys Matrix DFE-Gold Series Configuration Guide 21-69
Whenpreemptmodeisenabledthisspecifiesadelay(inseconds)thatahigherprioritybackup
routermustwaittopreemptalowerprioritymaster.Formoreinformationonsettingpreempt
status,referbackto“preempt”onpage 21‐67.FormoreinformationonsettingVRRPpriority,
referbackto“
priority”onpage 21‐64.
The“no”formofthiscommandclearsthepreemptdelaytimer.
Example
Thisexampleshowshowtosetthepreemptdelayto60secondsonVLAN1,VRID1:
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#preempt-delay vlan 1 1 60
enable
UsethiscommandtoenableVRRPonaninterface.
Syntax
enable vlan vlan-id vrid
no enable vlan vlan-id vrid
Parameters
Defaults
None.
Mode
Routercommand,Routerconfiguration:Matrix>Router(config‐router)#
Usage
BeforeenablingVRRP,youmustsettheotheroptionsdescribedinthissection.Onceenabled,you
cannotmakeanyconfigurationchangestoVRRPwithoutfirstdisablingitusingthenoenable
vlancommand.
The“no”formofthiscommanddisablesVRRPonaninterface.
Example
ThisexampleshowshowtoenableVRRPonVLAN1,VRID1:
Matrix>Router(config)#router vrrp
Matrix>Router(config-router)#enable vlan 1 1
vlanvlan‐id SpecifiesthenumberoftheVLANonwhichtoenableVRRP.This
VLANmustbeconfiguredforIProutingasdescribedin“Reviewing
andConfiguringRouting”onpage 2‐101.
vrid SpecifiestheVirtualRouterID(VRID)associatedwiththe
vlan‐id.Valid
valuesarefrom1to255.