Enterasys Matrix DFE-Gold Series

clear dot1x auth-config Configuring 802.1X Authentication
Enterasys Matrix DFE-Gold Series Configuration Guide 25-9
Thisexampleshowshowtoenablereauthenticationcontrolonportsfe.1.1‐3:
Matrix(rw)->set dot1x auth-config reathenabled true fe.1.1-3
Thisexampleshowshowtosetthe802.1Xquietperiodto120secondsonportsfe.1.1‐3:
Matrix(rw)->set dot1x auth-config quietperiod 120 fe.1.1-3
clear dot1x auth-config
Usethiscommandtoreset802.1Xauthenticationparameterstodefaultvaluesononeormore
ports.
Syntax
clear dot1x auth-config [authcontrolled-portcontrol] [keytxenabled] [maxreq]
[quietperiod] [reauthenabled] [reauthperiod] [servertimeout] [supptimeout]
[txperiod] [port-string]
Parameters
Defaults
•Ifnoparametersarespecified,allauthenticationparameterswillbereset.
•Ifport‐stringisnotspecified,parameterswillbesetonallports.
Mode
Switchcommand,Read‐Write.
Examples
Thisexampleshowshowtoresetthe802.1Xportcontrolmodetoautoonallports:
Matrix(rw)->clear dot1x auth-config authcontrolled-portcontrol
Thisexampleshowshowtoresetreauthenticationcontroltodisabledonportsfe.1.1‐3:
Matrix(rw)->clear dot1x auth-config reauthenabled fe.1.1-3
Thisexampleshowshowtoresetthe802.1Xquietperiodto60secondsonportsfe.1.1‐3:
authcontrolled‐
portcontrol
(Optional)Resetsthe802.1Xportcontrolmodetoauto.
keytxenabled (Optional)Resetsthe802.1Xkeytransmissionstatetodisabled(false).
maxreq (Optional)Resetsthemaximumrequestsvalueto2.
quietperiod (Optional)Resetsthe
quietperiodvalueto60seconds.
reauthenabled (Optional)Resetsthereauthenticationcontrolstatetodisabled(false).
reauthperiod (Optional)Resetsthereauthenti cati onperiodvalueto3600seconds.
servertimeout (Optional)Resetstheservertimeoutvalueto30seconds.
supptimeout (Optional)Resetstheauthenticationsupplicanttimeoutvalueto30
seconds.
txperiod (Optional)Resetsthetransmission
periodvalueto30seconds.
port‐string (Optional)Resetssettingsonspecificport(s).Foradetaileddescription
ofpossibleport‐stringvalues,referto“PortStringSyntaxUsedinthe
CLI”onpage 4‐2.