Enterasys Matrix DFE-Gold Series

Understanding RADIUS Snooper set radius-snooping
26-2 RADIUS Snooping Configuration
• GloballyenableRSontheswitch
•EnableRSonthoseportsyouwishenabledforsnooping
• OptionallychangetheperiodRSwillwaitforaRADIUS responseframefromtheserver
•ManuallypopulatetheRADIUSflowtablewithRSclientsandRADIUSservers
Commandoptionsalsoareavailableto:
•Terminateallsessionson
thesystemforthespecifiedportorforthespecifiedMACaddress
•ResetallRSconfigurationtothedefaultvalues
•ClearallRScounters
•Clearflowsfromallorthespecifiedflowtable
•DisplayRSstatistics
Purpose
Toenable,configureanddisplayinformationforRADIUSSnoopingusedbythenetworkmanager
tomanagedownstreamconnections,whenthefullcomplementofEnterasys’SecureNetworks
capabilitiesisnotdeployedatthenetworkedge.
Commands
set radius-snooping
UsethiscommandtogloballyenableordisableRSforthisdevice.
Syntax
set radius-snooping {enable | disable}
For information about... Refer to page...
set radius-snooping 26-2
set radius-snooping timeout 26-3
set radius-snooping port 26-4
set radius-snooping flow 26-5
set radius-snooping initialize 26-6
clear radius-snooping all 26-6
clear radius-snooping flow 26-7
clear radius-snooping flow 26-7
show radius-snooping 26-7
show radius-snooping port 26-8
show radius-snooping flow 26-9
show radius-snooping session 26-10